This is an entry level position that is designed to train you on the basic operation in the planer or sawmill. You will learn a variety of machines and tasks. The majority of your time is standing and walking. This includes frequently picking up pieces of board from table height or the floor. These boards weigh on average 5 - 35 lbs., occasionally more. The job involves clean-up activities including sweeping, shoveling and lifting. You will eventually be assigned to a specific area and will be trained to perform the operator's job in that area, to assist and "break-out" the operator. There may be some heavy lifting requirements on occasions. Once certified on a machine you will qualify for a pay increase.
Minimal sitting
Occasional repetitive hand movements.
Frequent bending, walking,
Frequent pushing, pulling, reaching.
Occasional twisting, climbing, stooping, kneeling
Occasional crawling or squatting
Sweeping/shoveling
Bending, pushing, lifting (up to 50 lbs)
Wood dust below the PEL
Occasional skin exposure to oil/grease
Temperature extremes (the work area is typically inside but not centrally heated or cooled. A local heater/ fan is provided)
Noise -hearing protection is required.
>1%: Cramped positions
65 - 85%: Standing
5% Sitting
65 - 80% Walking
5% Climbing (stairs/ladders)
35 - 45% Extended reach forward or overhead, push/pull/twist, grasp/handle, bend/stoop/squat,
5% fine hand dexterity,
5-15% repetitive motion operating a control console
5-15 pounds: Frequent
16-30 lbs: Moderate
31-45 lbs: Occasional
Greater than 46 lbs.: Minimal
MNCJobz.com will not be responsible for any payment made to a third-party. All Terms of Use are applicable.